Quark-elec Manual
https://www.quark-elec.com
27 of 30
2018
V2
14. Specialized units
14.1. Wireless PIR detector (G022P variant)
G022P series controller has a 433 MHz RF receiver module. It can pair with one wireless PIR (passive
Infrared sensor motion detector, also called a PIR sensor). Please note that G022P cannot pair with any RF mains
sockets.
G022P RF receiver module works at 433.92 MHz and can talk to the paired wireless PIR sensor within 25 meters
range in open areas. Once G022P receives an alarm signal from the paired PIR detector, Relay 3 will be activated
and locked until „
EXTRT
‟ has been sent to unlock Relay 3. The main mobile terminal will receive the warning
message „Port 3 has been triggered‟ at the same time.
The switch sockets are paired and ready to use if they are ordered together with G021/22. However the operator can
always pair or release the pairing by the following steps:
Switch off the PIR detector.
Power up G022P module, wait at least 60 seconds.
Using a small flat head screwdriver, press and hold the button on the receiver module. The LED light on the
receiver module will turn off. Release the button until the LED light turns on. Once the LED light turns on, the
memory on the module has been erased and is ready for pairing.
Figure 24: G022P module
Press the button on the module quickly again. The LED light will turn off again. Now the module is in „ready-
to-
pair‟ mode and will only stay in this status for 10 seconds. During these 10 seconds, switch on the PIR detector
with the sensor side facing the
operator‟s body. This allows PIR detector to send a detecting signal. The LED will
flash six times when the PIR is paired with the G022P module. If the pairing process could not be completed during
10 second, the operator can press the button again to repeat this step.
G022P will now be successfully paired with the wireless PIR detector.
Button on the
module
