![background image](http://html1.mh-extra.com/html/quantum/qxs-448/qxs-448_drive-rackmount-install-manual_3936363007.webp)
Install Rails (Square, Round, Pre-tapped Hole-Racks)
QXS 48-Drive Rackmount Install Guide
7
Install Rails (Square, Round, Pre-tapped
Hole-Racks)
This section provides the rail installation of three different types of racks. Information is as follows:
l
Square Hole-Rack Rail Installation below
l
Round Hole-Rack Rail Installation on page 12
l
Pre-tapped Hole-Rack Rail Installation on page 16
Square Hole-Rack Rail Installation
Complete steps 1–4 to install the rails.
1. For square-hole racks, install cage nuts in the front rack holes where chassis ears will be attached.
a. Before rail installation, refer to
Figure 5 below
for location of screws and cage nuts for the front
of the chassis.
Figure 5:
Screws and Cage Nuts for Chassis Front
1
2
4
3
4
3
4
3
4
3
1.
Left Rail
2.
Right Rail
3.
Screws Installed into Threaded Holes in Rail
4.
Cage Nut Installed (for chassis screws)
b. Before rail installation, refer to
Figure 6 on the next page
for location of screws and cage nuts for
the rear of the chassis.