Quantum Quantum ValueLoader, User Manual

Page: 16 / 90

Chapter 1 Installing the ValueLoader
Installation Overview
2 ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
Installation Overview
1
Installing the ValueLoader consists of the following steps, which are
explained in more detail later in this section..
1 Choose a location for the ValueLoader (see page 6 ).
2 Unpack and check the ValueLoader for shipping damage (see
page 7 ).
3 Identify the accessories that come with the ValueLoader (see page 8 ).
4 Install the ValueLoader in a computer rack or select a table or
desktop near the host server (see page 9 ). If installing a rack mount
unit, refer to your rack Installation Guide .
5 Shut down, turn off, and remove power from the server and all
devices attached to the server (see page 12 ).
6 Attach the SCSI cable to the ValueLoader and server’s SCSI host
adapter (see page 12 ).
7 Attach the power cable to the ValueLoader and plug in the power
cable to the nearest power outlet (see page 12 ). Power the
ValueLoader on to ensure it passes the Power-on Self Test (POST).
8 Set the SCSI ID for the ValueLoader (see page 14 ).
9 Set up the host and verify the connection (see page 14 ).
Understanding ValueLoader Features
1
The ValueLoader is a SCSI-2 low-voltage differential (LVD) data storage
device that incorporates an HP LTO-1 tape drive or HP LTO-2 tape drive
and eight tape slots. The ValueLoader occupies two SCSI target
addresses, one for the tape drive and the other for the autoloader
robotics.
The ValueLoader LTO-1 uses up to eight LTO Ultrium cartridges,
providing a maximum formatted capacity of 1.6 Terabytes (TB) and a
sustained data transfer rate as high as 1.8 Gigabytes (GB) per minute,
assuming a 2:1 compression ratio.