![background image](http://html2.mh-extra.com/html/quantum/p4000-series/p4000-series_user-manual_3854919086.webp)
Chapter 3 Operator Commands
Configuring Library Options
66
Quantum P4000 and P7000 Libraries User’s Guide
If you set up the library with multiple SCSI buses, you can assign the
same number to two or more devices, provided each device is on a
different SCSI bus.
Configuring Library Options
3
The
Configure Options
command allows you to set the following:
•
Power-On State
—determines whether the library is on-line or in
standby mode when powered up. The default setting is On-line.
•
AutoClean
—allows the library to perform drive cleaning tasks
automatically as needed. The default setting is Disabled.
•
Retries
—causes the library to automatically retry a failed command
before issuing an error message. The default setting is Enabled.
•
Bar Code Labels
—turns bar code scanning on or off during inventory.
It should be disabled when the library contains cartridges that are not
labeled. The default setting is Disabled.
•
Auto Inventory
—causes the library to perform an inventory whenever
the library is powered up. The default setting is Disabled.
•
Auto Load
—causes the library to automatically move cartridges in the
load port to empty storage bins as soon as the load port door closes.
The default setting is Disable.
•
Temp. Detection
—enables or disables the over-temperature detection
warning and shutdown features of the library. The default setting is
Enabled.
•
Power-On Security
—determines the library security level when
powered up. The default setting is User.
Note:
Power must be cycled for the new SCSI ID number to become
effective.
Note:
SCSI ID assignments are not required for Ethernet based
libraries.