SDLT 220 and SDLT 320 Product Manual
APPENDIX B: DLTtape IV Data Cartridge
81-85002-01
March 2004
B-5
cartridge. Gently press the hub and make sure that it springs back into place.
Make sure that it ends up centered within its circular opening.
6.
Ensure that the tape leader within the data cartridge is in the correct position.
To do this, open the data cartridge door by holding the DLT cartridge as
shown in
Figure B-3
.
Figure B-3.
DLT Tape Leader Loop in its Correct Position (Top View)
7.
On the right side corner of the data cartridge there is a small tab in a cut-out
portion of the cartridge. Using your thumb, gently lift up on the tab and swing
the door open.
Figure B-4.
DLT Tape Leader Loop in its Correct Position (Side View)
8.
Inside the door, you will see the tape and cartridge leader loop. The loop
should stick up about an eighth of an inch when viewed from the edge, as
shown in
Figure B-4
; the loop must be a closed loop. If the loop is torn, bent,
creased, pulled in, or not sticking up about an eighth of an inch, do not use the
data cartridge.
Open data
cartridge door
Leader loop
tilted up
Summary of Contents for DLTtape SDLT 220
