Quantronix CubiScan 125, Operation And Technical Manual, Page: 49 / 124

Operation Cubing and Weighing
CubiScan 125
39
N
OTE
If you have not already done so, remove the thin protective film that
covers the CubiScan 125 touch screen. Peel it back from one of the
corners using your fingernail, and then pull it off.
L
W
H
These display the measured dimensions in inches (in) or centimeters
(cm) as selected.
WEIGHT
This displays the measured weight in pounds (lb) or kilograms (kg)
as selected.
zero (indicator) This indicates that the platform is empty and ready to receive a
package. This indicator must be lit before you can place a package
on the platform. When you place a package on the platform, the
indicator goes off.
rdy (indicator) This indicates that the CubiScan 125 is ready for cubing and weigh-
ing.
home (indicator) This indicates that the measuring gate is positioned in the “home”
position (on the right-hand side).
Zero Tap this key to reset the sensors and scale to “zero” (make sure the
platform is empty). Refer to “Zeroing the CubiScan 125” on
page 44.
Menu Tap this key to go to the configuration menu to set up or calibrate
the CubiScan 125.
Measure Tap this key to display the weight and dimensions of the object on
the platform using the ultrasound sensors.
Cubing/
Weighing
Cuboidal Items
Take the following steps to cube and weigh a a cuboidal item using
the touch screen.
1. Verify that the CubiScan 125 platform is empty. The
zero
indi-
cator should be lit.
☞