10
Configuring the Physical Library
XLS Library Installation Manual
10-9
2.
After installing a MEM (18 columns of cartridge slots) select
Carousel18
from
the list.
3.
Press
Save Configuration
. When you press this button, the XLS adds the new
MEM slots to its internal databases.
4.
Enter the TPOS and XPOS values you obtained while aligning the gripper to the
MEM or expansion pod, as follows:
•
In the
Theta 1
field, enter the TPOS value for the MEM.
•
In the
X 1
field, enter the XPOS value for the MEM.
5.
Press
Update Alignment
. When you press this button, the XLS updates the
gripper alignment so it can access the new slots.
10.3
Calibrating an Expansion Pod Equipped Library
If you have attached a pods to the LRM, you must calibrate the pod to ensure that the
extra slots can be accessed.
Note:
If your XLS does not include a pod, skip this section and go to
.
Required tools and equipment:
Obtain the following:
•
Four pod Calibration cartridges (Qualstar part number: 521410) are needed to
calibrate each pod
•
Gripper Alignment Cartridge (Qualstar part number: 620059)
•
5/32" Allen wrench
•
Flash Light
Important:
The POD Calibration cartridges are
different
than the
Tape Drive Calibration cartridges and they are not
interchangeable. POD calibration cartridges must have
the CAL label attached.
Summary of Contents for XLS-810160
