9
Applying Power and Logging Into X-Link
XLS Library Installation Manual
9-3
9.2
Connecting the Library to Power
In addition to the standard power connection provided on the library there is a redundent
power input module available that allows the library to be connected to two independent
power sources, providing a redundant power source in the event one of the power sources
should fail. The unit powers the load from the first power input normally. The unit
switches to the second power input if the first has failed.
To power on a library with the standard power connection, follow these steps:
1.
Locate the power switch and power connector on the back of the library in the
lower left, as shown in
. Make sure the switch is off.
2.
Connect the power cord to the power connector.
3.
Plug the power cord into a wall outlet.
4.
If you plan to use a UPS, follow these steps:
a.
Connect the UPS cable (“UPS Communication Cable Smart Signaling”) to
the serial port on the XLS.
b.
Connect the UPS cable to the UPS.
Figure 9-1
Location of the power switch and power connector
Summary of Contents for XLS-810160
