Qualstar XLS-810160, Installation Manual

Page: 118 / 208

10.2 Aligning the Gripper with a MEM
10-4 501801 Rev. 07-01-19
10.1.2 Connecting to a Standalone Computer
To connect the XLS to a standalone computer, follow these steps:
1. Set the computer’s IP address to the following settings:
–
IP address: 192.168.0.245
– Subnet mask: 255.255.255.0
2. Insert one end of the Ethernet cable into the service port (ENET 1).
3. Connect the other end of the cable to the computer’s Ethernet port.
4. Start the Internet browser.
5. In the address line for the browser, type the default IP address for the service
port,
http://192.168.0.1 . See Figure 10-3 .
6. Press Enter . The X-Link log-in page opens.
7. Log into X-Link as described in Section 9.3 on page 9-11 .
10.2 Aligning the Gripper with a MEM
If you have attached a MEM to the LRM, you must align the gripper to the extra slots to
ensure that they can be accessed. Aligning the gripper includes the following steps:
• Using the gripper alignment tool to obtain Theta Position (“TPOS”) and X
Position (“'XPOS”) values (see
Section 10.2.1 )
• Updating the gripper alignment (see Section 10.2.3 on page 10-8 )
Note: If your XLS does not include a MEM, skip this section and go to
Section 10.4 on page 10-19 .
10.2.1 Using the Gripper Alignment Cartridge
To align the gripper to the carousel, follow these steps:
Figure 10-3 Entering the service port IP address (Internet Explorer shown)