64
Fig. 01
QSI0005
Fig. 02
QSI0037
CHANGE
(
Fig. 01
)
W a r n i n g :
hot oil
We recommend that the above operations are carried
out at an authorised Quadro dealership or by qualified
personnel.
An excessive quantity of engine oil may cause re-
duced performance, reduced peak speed and engine
overheating
Do not dump oil, dispose of only
at authorised facilities. Adhere
to the current legislation in each
country for disposal.
VEHICLE MAINTENANCE
•
Let the engine warm up for about five minutes then turn off.
•
Unscrew the drainage plug «
1 - Fig 01
», recover the spring
and mesh filter and let all the oil flow out into a sufficiently large
receptacle; remove the cartridge oil filter «
2 - Fig. 02
» and replace
it with a new one.
•
Insert the support spring and the mesh oil filter after cleaning it (
Fig.
01
) after which tighten up the drainage plug again «
1 - Fig 01
», to
the required torque.
•
A small amount of oil remains in the engine crankcase, fill up with
approx. 1.6 litres of new recommended oil (1.7 litres if you change
the oil filter, too) .
•
Check the level and top up if necessary until the correct level is
reached.
Tightening torques (Nm)
Engine oil drainage plug: 15
Summary of Contents for 3 2016
