5
Step 5: Secure Front & Rear Door
Surrounds to the Roll Bar Continued
Line up the rear end of the front door
surround with the front of the rear door
surround as shown in
Fi
g 16. Make
sure
the rear door surround seals are
on top of the front Door Surrounds as
shown
in Fig 17. Line up the rear
door sur
round bracket holes with the
vertical holes in the rear horizontal
roll bar. If you use a rolling motion
while you push the brackets on it will
be easier to install.
Slip the two knobs through the brackets
holes in the rear door surround. Loose
-
ly tighten the knob securing the front
door surround.
Note:
if you have difficult
lining up the top of the knobs with the
upper bracket hole, you can remove
the installed top brackets covering the
top hole to get a better view of how the
screw lines up. Repeat on the passenger
side of the vehicle.
FIG 16
FIG 17
Step 6: Installing the Center Bow #1
& #2
Locate the center bow #1 (Fig 18).
Each Bow has been labeled to make
identification easier. Loosen the
screws holding on the top brackets.
With the help of a friend, place the
Quick release end on the bottom of the
bow leg over the second vertical brack
-
et (Fig 19). Pull the quick release knob
out and push the bow down mounting
the quick release to the bracket.
The quick release knob is spring load-
ed so you should here a “click” when it
is secure in the bracket (Fig 20). once
the bow is installed, tighten the bow
mount bracket on the door surround.
FIG 18
Center Bow #1
Center Bow #2
FIG 19
FIG 20
Repeat this bow mounting on the other
side of the vehicle and then repeat
the above procedure with center bow
#2 (FIG 18). Tighten down the door
surround knobs on each side of the
vehicle securing the Door surrounds
and the two bows.
