Pillar and Over Door Surround Assembly
Locate the driver’s side Rear over door assembly
and the driver’s side Pillar assembly shown in
FIG16.
Turn the two pieces over as shown in FIG17 and
line up the slot on the pillar assembly with the “T”
on the over door assembly. Notice in Fig 17 that
there is a secondary “T” that will be lined up when
you slide the long “T” into the long slot. Slide the
two pieces together lining up both “T’s”
to secure the top over door assembly with the
Pillar assembly. See FIGs 18 &19.
Locate the small screw packet in the hardware kit
found in the door surround box. Using a Phillips
head screw driver, install the screw into the two
screw holes on the two assembled parts securing
them permanently together. See FIG20
Repeat the above assembly on the Passenger
side Rear over door and pillar assemblies.
Install Foam to Front Door Surrounds
Locate the driver’s side front door surround and
the rectangular piece of foam found in the door
surround hardware pack. Line up the foam wit
h
the rear of the door surround and measure the
length between the rear of the door surround and
the top of the curve (FIG21).
With a pair of scissors, cut the foam to size.
Remove the backing on the foam and secure
it to the front of the door surround as shown in
FIG
22. Make sure not to cover the hole in the
door surround.
Repeat this procedure on passenger side door
surround.
4
FIG 15
FIG 14
FIG 16
FIG 17
FIG 18
FIG 19
FIG 20
FIG 22
FIG 21
Summary of Contents for 11113.1435
Page 14: ...14...
