Important Safety information
Your QuadraTop® Fabric Replacement Top
is intended to be used with other QuadraTop
Products to increase the fair weather enjoy-
ment of your off-road capable vehicle. Before
installation,
please take a moment to review the following
safety information and installation instructions.
Important safety information is generally prece-
ded by one of three signal words indicating the
relative risk of injury.
The signal words mean.
a hazardous situation which, if not avoided, could result in death or serious in-
jury. You CAN be KILLED or SERIOUSLY HURT if you don’t follow instructions.
WARNING
CAUTION
NOTICE
a hazardous situation which, if not avoided, could result in minor or moderate
injury. You CAN be moderately HURT and also may suffer property damage if
you don’t follow instructions.
Careful attention is required to this instruction or operation but does genera-
lly not relate to personal injury. Damage to your Quadratec® product or other
property may result if you don’t follow instructions.
Before you begin Installation:
We are excited that you have chosen the
Adventure Top
. This high-quality soft top is
designed to provide protection from the
elements and a stylish look on your Jeep®.
Please note that it is important that you
become familiar with the installation process
of this top
reading the following instruction sheet and
warnings thoroughly.
When unpacking, carefully check to make sure
all parts are included. If any part is missing
or broken, please call Quadratec customer ser-
vice at 800-745-6037. When unpacking, check
to make sure all parts are included.
For a smooth fit and ease of installation, this top should be installed at tempe
-
ratures above 72 degrees. Below this temperature, the fabric may contract an
inch or more making it difficult to install. We highly recommend taking the top
out of the package and letting it sit inside a warm place or direct sunlight for
1-2 hours before you install the top. When warm, this top will install quickly.
NOTICE
2
Step 1: Install Over Door Bows to Front
Header Assembly
Locate the Fabric/Header assembly and
the two over door bows as shown in Figs
1 & 2 and place the assembly on a table
top or on a soft
towel with the underside facing up and the
two “header legs” facing away from the
header.
Locate the over door bow
assembly (Fig 3) and round bow/header
sleeve (round tube).
Slip the round door “sleeve” over the
header leg and insert the “knuckle”
installed on the
over door bow into the Header leg (Fig 4)
making sure the quick release knuckle is
facing outward (Fig 5).
FIG 2
FIG 1
FIG 3
FIG 4
Summary of Contents for 11113.1435
Page 14: ...14...
