RR
R
December 22, 2006
7005-151D
Page 31
Mt. Vernon Pellet Stove
E. Baffle Removal
a. Allow appliance to cool completely.
b. Open door.
c. The baffle is located at the top inside of firebox.
d. Place your hand on the baffle for support as the cast
is heavy. Using a 5/32 Allen wrench loosen the latch
(shoulder bolt) by turning counterclockwise, lower the
baffle and pull forward.
Figure 31.1.
e. To replace the baffle, place the bolted on bracket located
at the rear of the baffle over the lip of the rear brick.
f. Position the baffle in place and re-tighten
the latch
(shoulder bolt) with an Allen wrench by turning clock-
wise.
Figure 31.2.
Baffle
Loosen Latch
Rest on lip
of rear brick
Baffle
Figure 31.1
Figure 31.2
F. Glass Replacement
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury
WARNING
Rope Retainer
Rods
Slide this end
in first
Crimped end at
the bottom
Crimped end
must be
parallel with
the glass
Glass
Figure 31.3
• Frequency:
As needed
• By:
Qualified Service Technician/Homeowner
• Task:
a. Open the face and remove door from the appliance
by lifting door off of hinge pin and lay on a flat
surface face down.
b. Using a screwdriver, tap the bottom of the rope
retainer rod to push it up out of the hole. The top
end of the rod will slide up. Swing the rod toward
you from the bottom and remove the rod. Repeat
for other side.
c. Remove old glass and replace with new glass.
d. Slide the retainer rod into the top hole first, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be parallel with the
glass in order to insert it into place.
Figure 31.3.
WARNING
Cast iron is a very heavy material.
All of the
brick pieces and baffle are made of cast iron
and therefore are heavy and awkward at times
to maneuver. Clear and prepare your work area
before you begin.
f i r e - p a r t s . c o m
