Page 18
7005-151D
December 22, 2006
R
Mt. Vernon Pellet Stove
RR
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
1. Put a layer of high temperature silicone on the
3 inch (76mm) exhaust outlet.
Figure 18.1
2. Slide the top vent adapter onto the rear exhaust
outlet and adjust the assembly to a vertical position.
Figure 18.1
3. Drill 4 holes with #26 drill bit (provided) into the
back of the appliance using the outer shield as
a pattern (make sure the assembly is vertical).
Figure 18.2
4. Install the 4 mounting screws.
5. Drill 2 holes with #26 drill bit through the rear
exhaust outlet using the 2 holes already in the short
horizontal pipe in the top vent adapter as a guide.
Install the 2 screws.
Figure 18.1
6. Install the vent pipe into the top vent adapter (be
sure to silicone all joints).
7. To clean top vent adapter, open clean-out cover.
Figure 18.2.
C. Top Vent Adapter Installation
3 in. to 6 in.
Offset
Adapter
3 in. to 3 in.
Top Vent
Adapter
Use hole on each side
as drilling guide
Silicone
Rear Exhaust
Outlet
Drill holes in
back of stove
and secure with
4 screws, 2 on
each side
Clean Out Cover
Figure 18.2
Figure 18.1
Installing the Top Vent Adapter
D. Rear Vent and Rear Vent to Top Vent
Adapter Installation
Clean-Out Cover
Clean-Out Cover
Figure 18.3 - Rear Vent Adapter
Figure 18.4 - Rear to Top Vent Adapter - 90
o
1. Put a layer of high temperature silicone on the 3 inch
(76mm) exhaust outlet.
Figure 18.1.
2. Slide the adapter onto the rear exhaust outlet and
adjust the assembly to the appropriate position.
3. Install the vent pipe into the adapter (be sure to
silicone all joints)
f i r e - p a r t s . c o m
