RR
R
December 22, 2006
7005-151D
Page 17
Mt. Vernon Pellet Stove
7
Appliance Set-Up
A. Leg Leveling System
Figure 17.3 - Bolt fully extended
Figure 17.2
Figure 17.1
1. Thread Allen bolts through nuts until flush.
Figure 17.1.
The Allen bolts and nuts are included in the component
pack inside the stove firebox.
2. Slide assembled nuts and bolts into slots on legs with
the nuts on the bottom.
Figure 17.2
. Use a 5/32 in.
(3.96mm) Allen wrench to adjust legs up and down to
desired level.
Figure 17.3
B. Outside Air Kit Instructions
Flex Hose
Hose Clamp
Collar Assembly
Trim Ring
Termination
Cap Assembly
Hose Clamp
Parts Included in Kit:
1 piece of
2 inch x 3 foot flex hose, 2 hose
clamps, 1 collar assembly,1 termi-
nation cap assembly, 1 trim ring,
12 screws.
1. Measure distance from floor to air vent opening in appli-
ance and mark location on wall.
Use saw to cut opening in wall. Cut a 2-1/2 to 3 inch
(64-76mm) opening on inside wall and a 3 to 3-1/2 inch
(76-89mm) opening on outside of house.
2. Use hose clamp to secure flex pipe to collar assembly.
3. Slide trim ring over flex pipe and run pipe through wall.
4. Attach hose to outside termination cap with second
hose clamp.
5. Secure termination cap to outside surface.
6. Secure trim ring to interior wall.
Tools Needed:
Phillips head-
screwdriver; wire cutters; hole
saw or jig saw.
Collar Assembly
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
Figure 17.4
f i r e - p a r t s . c o m
