RR
R
December 22, 2006
7005-151D
Page 19
Mt. Vernon Pellet Stove
D. Optional Log Set Placement Instructions
1. Place the rear logs as shown. Be careful not to block
the drop tube in the back of the firebox where pellets
feed into the firepot.
Figure 19.1
2. Place the large front log in the front moving it to the
right side. The exhaust exists on the left and that must
not be blocked.
Figure 19.2
1. Place the top log over the other 3 logs. It must rest on
the logs in a stable position.
Figure 19.1
3 PIECE LOG SET INSTALLATION
OPTIONAL TOP LOG INSTALLATION
Figure 19.2
Feed Tube
Exhaust Exits on the Left
Do Not Block
Move to Right
Figure 19.3
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
1
.
A 12 volt AC thermostat is required to operate this pellet
appliance. You may use the included wall mount thermo-
stat or purchase an optional programmable thermostat
or remote control. It is equipped with an adjustable
heat anticipator. The current rating is .05 amps. The
anticipator needs to be adjusted to the lowest setting
available.
2. When mounting a thermostat on a wall, be sure to follow
your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for
accurate readings. The thermostat should be
mounted on an inside wall and not in direct line
with the appliance convection air.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired
temperature in your home.
3. There is a 4 screw terminal block located on the back
lower left corner of the appliance directly above the power
cord inlet. The center 2 screws are for the thermostat
wires.
E. Thermostat Installation
TERMINAL BLOCK
CENTER 2 SCREWS FOR
THERMOSTAT WIRES
POWER OUTLET
FUSE
Fuse
Fuse
Figure 19.4
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
CAUTION
f i r e - p a r t s . c o m
