GARNET DIRECT VENT ROOM HEATER
250-6443B October 7, 2003 Page 9
R
GARNET DIRECT VENT ROOM HEATER
250-6443B October 7, 2003 Page 10
R
Installation:
1. Place the notch in the Rear Log
over the Thermopile. Push the
log all the way to the rear of the
firebox
(Fig. 1).
2. Place the hole in the bottom of the
Left Twig over the left pin in the
Rear Log
(Fig. 2).
3. Place the hole in the bottom of the
Right Twig over the right pin in the
Rear Log. Lay the end of the twig
in ember bed
(Fig. 3).
4. A complete assembled Log Set is
shown in
Fig. 4.
5.
The lava rock supplied with the
stove can be poured in the trays
along the left and right sides of
the burner pan.
NOTE: Do not pour any of the lava
rock onto the burner (Fig.4).
LOG SET INSTALLATION
Complete Set Part 842-4980
Qty Name
Diagram
1
Rear Log
Fig. 1
1
Left Twig
Fig. 2
1
Right Twig
Fig. 3
1
Lava Rock
Fig. 4
While breakable, the logs do not become fragile until after
the stove is burned and they have cured. After curing, any
handling must be done with care as breakage may occur
easily.
PLEASE NOTE: Logs have been designed to work
specifically with the burner of the Garnet. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
The three piece log set is packed in the components
box and consists of the following:
Notch over Thermopile
FIG. 1
FIG. 2
FIG. 3
Lava Rock
FIG. 4
MINERAL WOOL INSTALLATION
Apply dime size pieces sparingly along front edge of burner. Do not completely block ports.
COMPLETE INSTALLATION
