22
7014-258B
November 30, 2017
CB1200 FREESTANDING
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
D. Optional
Log Set Placement Instructions
1. Place the front log in first as shown in
Figure 22.1
. Place
log between fire pot and face of appliance with charred
area surrounding fire pot.
2. Set the left and right logs onto the front log, placing
the holes in the base of the left and right logs over the
locating pins in front log. See
Figure 22.2.
Ensure that
the charred ends are facing the fire pot.
Figure 22.1
NOTE:
Due to the abrasive nature of a pellet appliance fire, the logs
are not covered under warranty. Any placement variation
other than shown here can cause excessive heat and shall
void the appliance warranty.
LOCATING PINS
Charred Areas in the Back
Top Log
Right
Top Log, Left
Front Log
Figure 22.2
Install Logo
E. Installing Logo
1. Remove logo from packaging.
2. The logo has 2 studs on the back.
3. Install the logo on the lower left side of the center panel
by pressing the 2 studs into the already drilled holes.
See
Figure 22.4.
Figure 22.3
F. Thermostat Installation and Operation
There is a 4 screw terminal block located on the back
lower left corner of the stove directly above the power
cord inlet. The center 2 screws are for the thermostat
wires (see
Figure 23.1 on page 23
)
.
The appliance comes standard with a wall thermostat and 25’
of wire. If you need to run more than 25’ make sure you use
a continuous strand of 18 to 22 gauge thermostat wire. For
optimum performance your thermostat should be located on
an inside wall approximately 5’ up from the floor.
How to Install Your Wall Thermostat
1. Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart
2. Connect your thermostat wire to the W and R terminals
(see
Figure 23.2 on page 23
)
3. Screw the backer plate to the wall using the hardware
included
4. Snap the thermostat to the backer plate
5. Connect the wires to the 2 center screws on the terminal
block on the back of the product
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front of appli
-
ance.
CAUTION