![background image](http://html2.mh-extra.com/html/quadra-fire/cb1200m-mbk/cb1200m-mbk_installation-manual_3416015005.webp)
November 30, 2017
7014-258B
5
CB1200 FREESTANDING
• Installation and use of any damaged
appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with
appliance).
• Do NOT Over fire
Or any such action that may cause a fire hazard.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
Reciprocating Saw
Channel Locks
Hammer
Phillips Screwdriver
Tape Measure
Plumb Line
1/4” Self-Tapping Screws
Framing Material
Hi-temp Caulking Material
Gloves
Safety Glasses
Framing Square
Electric Drill & Bits (1/4”)
Level
May also need:
Vent Support Straps
Venting Paint
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
C. Tools And Supplies Needed
B. Thermostat Wall Control Location
The
thermostat wall control’s
location will have some affect
on the appliance
’s operation.
• Maximum wire length from appliance is 100 feet (30.48m)
continuous non-spliced wire. Recommended 20 gauge
wire, solid copper
.
•
When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of the
house comfortable.
•
When located
in an adjacent room or on a different floor
level, you will notice higher temperatures near the appli-
ance.
D. Inspect Appliance and Components
WARNING! Risk of Fire!
Damaged parts could impair
safe operation. Do NOT install damaged, incomplete or
substitute components.
•
Open the appliance and remove all the parts and articles
packed inside the Component Pack. Inspect all the parts
and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
•
All labels have been removed from the glass door.
•
Plated surfaces have been wiped clean with a soft cloth,
if applicable.
• Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
• Follow pipe manufacturer instructions for installation
and air clearance requirements.
Risk of Fire!
Damaged parts could impair safe operation.
Do NOT install damaged, incomplete or
substitute components.
WARNING