Wyvern 200 Assembly Guide
Central Stack Assembly
CENTRAL STACK ASSEMBLY
STEP 1, INSERT PDB AND FC BOLTS
Start the stack assembly by installing the
Nylon Bolts
(D) through the inside holes in
the corners. The bolts are held in place with
a nylon nut as shown in the picture to the
left.
At this point in time you can continue with
the electronics installation if desired or you
can install the standoffs first as described in
Step 2 below.
STEP 2, PLACE BATTERY STRAP AND BATTERY PLATE
The orientation of the battery strap and the
Battery Plate
(C) must align with the
orientation of the
Bottom Plate
(B).
The picture to the left shows the
orientation of these two components, the
narrow segment of the
Battery Plate
(C)
must align with the wider section of the
Bottom Plate
(B). This provides the
opening for the battery strap to sit in and
will allow movement back and forth for the battery strap.
When replacing the battery strap it is easier to do this if you loosen the bolts that
hold the
Battery Plate
(C) to the main frame sandwich as this will slightly enlarge
the opening and make it easier to slip the old battery strap out and the new
battery strap in. In some cases you may find it necessary to loosen two of the
bolts remove the other two bolts and slip the battery straps in and out from the
end of the frame.
Summary of Contents for Wyvern 200
Page 1: ...WYVERN 200 ASSEMBLY GUIDE...
