Wyvern 200 Assembly Guide
3D Printed Parts and Top
3D PRINTED PARTS AND TOP
STEP 1, INSTALL RECEIVER TRAY
Slide the
Receiver, VTX, LED and Antenna
Tray
(K) over the two rear standoffs (the
ones closes to the power lead stress relief
tab). This piece will hold all the listed
components:
•
The receiver is mounted to the flat tray
using double sided tape or other
mounting mechanism.
•
The antenna tubes are installed in the
provided slots.
•
The VTX is installed through one of the two provided holes using the SMA
connector on the VTX and the antenna or a nut. Since not all SMA connectors are
the same length please ensure that the antenna is completely seated and that you
have a connection. If the VTX is loose after the antenna is completely tightened
you will need to use washers or an additional nut to solidly mount the VTX.
•
LED installation is shown below.
STEP 2, INSTALL CAMERA
Prepare the camera assembly off the quad before installing it. The camera
mounts to the
Camera Plate
(L) using the provided
M2 X 8mm
(F) bolts. The
camera installs from the rear (the side that is not smooth) and the bottom of the
camera aligns with the narrow side of the
Camera Plate
(L) (the side with the
rounded corners).
Summary of Contents for Wyvern 200
Page 1: ...WYVERN 200 ASSEMBLY GUIDE...
