Wyvern 200 Assembly Guide
Central Stack Assembly
STEP 3, INSTALL BATTERY PLATE AND STANDOFFS
The battery strap can now be permanently installed. It is held in place using the
Battery Plate
(C) and
the M3 X 14mm Bolts
(J). The battery plate bolts will screw
into the
40mm Standoffs
(C). This is another place where you can use thread-‐
locking compound if desired.
STEP 4, INSTALL PDB AND FLIGHT CONTROLLER
If you did not install your electronics in Step
1 above then you can install them here. The
PDB
(B) is held down by the
Nylon
Standoffs
(D) and the flight controller
board is held down by the final set of
Nylon
Nuts
(D).
Summary of Contents for Wyvern 200
Page 1: ...WYVERN 200 ASSEMBLY GUIDE...
