Wyvern 200 Assembly Guide
Introduction
INTRODUCTION
This document provides an overview of the assembly steps for the Quad
Monsters Wyvern 200 Racing Frame. It is not meant to be a comprehensive guide
describing all the necessary steps in building a quadcopter and installing all the
necessary equipment. Instead, it explains in detail how the platform comes
together that you will install your equipment on.
Individual equipment choices will dictate variance in the final assembly of the
REQUIRED COMPONENTS
Although as a builder you can choose most of the equipment in the Wyvern 200
there are a few specific components that were used in the design of the frame in
order to optimize its characteristics. The following is a list of the components you
will need to use if you plan on building the frame as specified by Quad Monsters.
MOTORS
The arms for the Wyvern 200 have been cut specifically for 22XX motors; 18XX
bolt patters will not work on this frame without modifying the arms.
The specifics on the hole pattern are
∅
16mm to
∅
19mm and m3 bolts.
CAMERA
The provided camera mount is designed around a 28mm X 28mm board camera.
We use the RunCam PZ0420M
VTX
The designed mounting for the VTX is through the antenna connector. There are
many VTXs that will work but they need to have a straight (not 90°) antenna
connector on the narrow end of the board.
Summary of Contents for Wyvern 200
Page 1: ...WYVERN 200 ASSEMBLY GUIDE...
