QSI QS-2plus!, Manual

Page: 88 / 140

u
Section 6 RESET Feature Guide 88
#46: Flange Sounds Enable
Flanges are the rims on engine wheels that extend below the rail to prevent the
wheels from slipping off the track. When moving through tight curves, these
flanges often squeal as they rub against the sides of the rails. You can get the
same effect .
There are three ways to operate the flange sounds. You can choose to turn off
the flange sounds completely ("Flanges Off"). Or you can choose "Flanges Arm
Enabled." When using Flanges Arm Enabled, you decide when to hear the
flanges by arming them with the bell or horn button. Once the flanges are
armed, they will sound the next time you use the Horn Button as described
below. The third choice is to always have flange sounds when you use the Horn
Button as described below; arming is unnecessary. This choice is called
"Flanges Always."
The factory default setting is "Flanges Off."
T o E n a b l e / D i s a b l e , o r T u r n O n / O f f F l a n g e S o u n d s
••
Find RESET Position #46
••
Press the Horn Button
Each time you press the horn button you will hear one or two "dings."
1 "ding" = "Flanges Off:" Turns off the Flange Sounds completely.
2 "dings" = "Flanges Arm Enabled:" Flanges are enabled. You can arm
and hear the flanges when you follow the steps on the next page.
3 "dings" = "Flanges Always:" Flanges will sound every time you press the
horn button as described in step 3 on the next page. You do not
need to arm them first.
Screeeeeeeech!
You may want to turn on the engine's flange sounds
ding, ding, ding