QSI QS-2plus!, Manual

Page: 35 / 140

Section 5 Assigning and Using ID Numbers
u
35
Note: If you accidentally put the wrong engine into Engine Plus, press the bell
button for 1.5 seconds again, and the engine will be disarmed for the Engine
Plus group. When you disarm this engine, you will not hear any feedback
sounds. Now continue to press and release the horn button until you reach the
engine you did want, and hold the bell button down 1.5 seconds to arm it for
Engine Plus.
•
Interrupt the power and move this engine into position with your train
•
Do a RESET
•
As you select another engine using its ID number, continue to hold the
Horn Button down for 1.5 seconds
This engine is also armed for Engine Plus.
•
Interrupt the power and move this engine into position with your train
Continue until you have armed and positioned all the engines in your consist.
•
Do another RESET
•
Press the Bell Button for 1.5 seconds
The Engine Plus Group is selected, and any engines you had not selected for
the Engine Plus Group are de-selected and will remain silent and motionless.
Interrupt the power and the Engine Plus Group will start up and run together.
If you do a Hard RESET (turn off the power for 15 seconds or more), all
Engine Plus armed engine will be disarmed.
Note: Once any engine is armed for Engine Plus, you can choose to make it a
slave or master engine in RESET Position #4. The engine will not behave like a
slave engine until it is added to the consist and the bell button is pressed 1.5
seconds, selecting the Engine Plus Group.
#4
#2
#3
Rumble
Rumble
Rumble
Select an Engine Plus Group with the bell button