QSI QS-2plus!, Manual

Page: 82 / 140

u
Section 6 RESET Feature Guide 82
#40: Lock-out Enable
Instead of using a mechanical switch (like the lever on an E-unit), you can now
lock-out your engine by remote control. Lock-out locks your engine in one
direction (forward, neutral or reverse), so it can be used with block signals or
stop stations that would normally cycle the engine into neutral. The bell,
whistle, squealing brakes and coupler still work.
The QS-2+ engine can be locked out and returned to normal operation any time
you are running your engine, but before you can use lock-out, you must first
enable lock-out using this RESET Feature.
The factory default setting is "Disabled."
T o E n a b l e o r D i s a b l e L o c k - o u t
••
Find RESET Position #40
••
Press the Horn Button
Each time you press the horn button you will hear one or two "dings."
1 "ding" = "Disabled"
2 "dings" = "Enabled"
Press the horn button to enable Lock-out
T o L o c k - O u t Y o u r E n g i n e
•
While your engine is running in the desired direction, press the Horn
Button and turn off the power with the throttle
while holding the Horn
Button down
•
Release the Horn Button
•
After a short period (1 to 2 seconds) you will hear a short whistle or
horn blast. Turn the power back on
immediately. Your engine is now
locked out (continued on the next page.)
ding, ding