XCubeFAS 2026
Hardware Manual
Installing the System Hardware
© 2021 QSAN Technology, Inc. All rights reserved.
www.qsan.com
Official
Document
35
Mount the System Chassis into a Rack
4.
Insert the chassis to complete the installation.
Pull the middle member fully extended in locked position.
Ensure ball bearing retainer is located at the front of the middle member.
Insert chassis into middle-outer member.
When hitting the stop, pull/push release tab to unlock and retract chassis into rack.
Use M5x20 screws to fasten the chassis ear.
Figure 3-8 Fourth Step of the Slide Sails Installation
3.4.
Installing the Trays into the System
Before installing, please check if the carrier handle is at the open position. The following
procedure is for installing a tray into SFF systems.
The following content and images are detailed steps for installing a tray into the system.
1.
Align a disk drive with the tray to the empty bay you would like to install and then push it all
the way into the disk drive bay until the carrier handle is at closed position.
2.
Lock the release button lock by pushing the lock from right to left. Refer to the label on the
system chassis for disk drive numbering. (Disk drive numberings are printed on the chassis.)
