Setting
User Action
Enable DHCP server
Configure the DHCP server settings.
• Start IP address: Specify the starting IP address in a range allocated to
DHCP clients.
• End IP address: Specify the ending IP address in a range allocated to
DHCP clients.
• Lease time: Specify the length of time that an IP address is reserved for
a DHCP client. The IP address is made available to other clients when the
lease expires.
• Configure the DNS server settings:
• Use the fixed IP address: Select to use the same IP address assigned
for the fixed IP address.
• Manually: Manually configure the DNS server IP addresses.
Note
QNAP recommends specifying at least one DNS server to
allow URL lookups.
Reserved IP Table
• Click Add to configure a reserved IP table.
• Specify the following:
• Device name
• IP address
• MAC address
•
Click
.
8. Configure the IPv6 address assignment settings.
a. Click IPv6.
b. Click Enable IPv6.
c. Select the outgoing WAN interface from the drop-down list.
d. Specify the IPv6 IP address prefix.
e. Select the prefix length from the drop-down list.
f. Select the interface identifier to identify interfaces on a link.
Setting
User Action
Interface identifier
Select from the following:
• EUI-64: Select Extended Unique Identifier (EUI-64) to automatically configure IPv6
host address.
• Manually: Specify an interface ID to configure the IPv6 host address.
g. Assign a client IPv6 addressing mode from the drop-down list.
QHora-322 User Guide
Network Settings
36
