QMS 1725E, Getting Started Manual, Page: 64 / 94

Configuring the Interface
QMS 1725E Print System Getting Started 4-12
2 In the Administration/Communications/ Network 2 /CrownNet/
NetWare/Config PServer/PServer Name[1], PServer Name[2],
and PServer Name[3] menus, enter the name of the config-
ured print server.
» Note: The three PServer Name[x] menus allow you to identify one print
server with a name up to 48 characters long. (Up to 16 characters can
be entered in each of the three menus). You cannot use these three
menus to identify three print servers.
Spaces and lowercase characters are not allowed in print server
names. However, underscore characters (_) are allowed to simulate
multiword names (for example, PUBS_PSERVER). At the printer control
panel only, a space must be used following the last character of the
print server name to end the name.
3 In the Administration/Communications/Network 2/CrownNet/
NetWare/RN Printer/Printer Slot # menu, enter the printer slot
number.
» Note: This number must match the slot number chosen in the Printer
Configuration submenu of the Print Server Configuration menu in the
NetWare PCONSOLE utility.
4 In the Administration/Communications/Network 2/CrownNet/
NetWare/RN Printer/PServer Name[1], PServer Name[2], and
PServer Name[3] menus, enter the name of the print server.
» Note: The three PServer Name[x] menus allow you to identify 1 print
server with a name up to 48 characters long. (Up to 16 characters can
be entered in each of the three menus). You cannot use these three
menus to identify three print servers.
Spaces and lowercase characters are not allowed. However, underscore
characters (_) are allowed to simulate multiword names (for example,
PUBS_PSERVER). At the printer control panel only, a space must be
used following the last character of the print server name to end the
name.
5 Reset the NIC by using the Administration/Communications/
Network 2/CrownNet/Common/Soft Reset menu.
6 Skip to “Configuring the Network,” later in this chapter.