Output
Problems
QMS 1660 Print System Operation
6-30
n
If the End Job Mode option is set to None, and if an EOD com-
mand is inserted between each print job, the EOD commands
may cause the printer to select the incorrect emulation or to print
the EOD command on your print job.
Multiple Pages Problem
If you’re experiencing unexpected results when printing multiple pages,
try turning collation off (Operator Control/Collation menu) so that the
memory used for compressed pages can be released after it has been
used. See chapter 4, “Printer Configuration,” in the
Reference
for more
information on collation.
NetWare Banner Page Job Doesn't Print
If you have a problem printing a job using NetWare with a banner
page, change the Administration/Communications/Network 1/
Inter-
face
/PS Protocol or Administration/Communications/Network 2/
CrownNet/PS Protocol value to QBinary or QBinary Fixed.
Not All Pages Print
n
Check the cable connecting the printer and the host. You could
have the wrong kind of cable, or your printer may not be config-
ured for the correct cable and port.
n
Make sure no one pressed the Cancel key while your job was
printing.
n
Check the control panel message window to see if the paper cas-
sette or multipurpose tray is out of paper.
Orientation Problem
If you have manually set the orientation (landscape or portrait) through
the control panel and your image doesn’t print correctly, you may be
experiencing an orientation problem. The preferred method to set
orientation is through your application.
Summary of Contents for 1660
