3 – Virtual I/O Command Line Interface
Groups and Commands
D000025-002 Rev. A
3-77
A
Options:
Sample Output:
NOTE:
Link aggregation can be configured on a per-port basis to be determined
automatically (via 802.3ad Lacp) or manually configured. This command
allows the user to setup the port(s) into manually configured aggregations.
The aggregation index is an arbitrary, non-zero index, and must refer to
either an aggregation not currently in use, or one that has already been
configured manually. Since manually configured configurations do not use
Lacp, the user will also need to physically verify that the ports used in the
aggregation are connected to the same switch, and that the switch is also
manually configured to have those ports in an aggregation. Use aggregation
index 0 to remove the port(s) from their respective manually-configured
aggregations (note this does not re-enable Lacp for the ports). The port
parameter can be either a single port, or a list of ports separated by spaces
and enclosed in double quotes.
ethExtLacpFailoverGet
Display the minimum number of active ports required for Link Aggregation failover.
Syntax:
Options:
port
External Ethernet port (or list of ports) to configure into a manual aggregation.
aggIdx
Index/identifier for the manual aggregation to configure the port(s) into.
-> ethExtAggregationSet 1 1
External Ethernet port 1 [Ext-1] manually configured into aggregation 1
ethExtLacpFailoverGet port
port
Port, list of ports, or '-all', indicating which ports to display.