Qlogic QLA200 HBA, User Manual

Page: 14 / 54

2 – HBA Installation
Installing the QLA200 HBA
2-2 FL0054601-00 B
Step 2. Install the low-profile bracket (optional).
❑
Remove the two screws that attach the current bracket to the HBA.
Retain the screws to re-attach the new bracket
(see figure 2-1) .
Figure 2-1. Low-Profile Bracket Installation
❑
Remove the current bracket by sliding it off the transceiver housings.
Set the bracket aside.
❑
Position the new bracket over the transceiver housings. Gently press
the bracket into position. Make sure the mounting tabs with the threaded
holes are positioned on the far side (the side opposite the transceiver)
of the QLA200 HBA.
❑
Align the screw holes of the QLA200 HBA and the bracket, then insert
and tighten the screws. Correct torque is 3.6-in/lbs.
BRACKET
SCREW
SCREW