Qlogic FastLinQ 3400 Series, User Manual

Page: 260 / 287

15–QLogic Teaming Services
Event Log Messages
232 83840-546-00 E
9 Informational Network controller
configured for 1Gb
full-duplex link. The adapter has been
manually configured
for the selected line
speed and duplex set-
tings. No action is required.
10 Error Unable to register the
interrupt service rou-
tine. The device driver can-
not install the interrupt
handler. Reboot the operating
system; remove other
device drivers that
may be sharing the
same IRQ.
11 Error Unable to map IO
space. The device driver can-
not allocate mem-
ory-mapped
I/O to access driver
registers. Remove other adapt-
ers from the system,
reduce the amount of
physical memory
installed, and replace
the adapter.
12 Informational Driver initialized suc-
cessfully. The driver has suc-
cessfully loaded. No action is required.
13 Error Driver initialization
failed. Unspecified failure
during driver initializa-
tion. Reinstall the driver,
update to a newer
driver, run QCC GUI
diagnostics, or replace
the adapter.
14 Error This driver does not
support this device.
Upgrade to the latest
driver. The driver does not
recognize the installed
adapter. Upgrade to a driver
version that supports
this adapter.
15 Error This driver fails initial-
ization because the
system is running out
of memory. Insufficient system
memory prevented the
initialization of the
driver. Increase system mem-
ory.
Table 15-9. VBD Event Log Messages (Continued)
Message
Number
Severity Message Cause Corrective Action