Qianjiang QJ150T-10, Operation And Maintenance Manual, Page: 45 / 131

- 44 -
*Note
The metal area of the avometer prod mustn't be touched
by fingers to prevent electroshock.
If the peak voltage of the CDI terminal has an abnormal value,
disassemble the body guard and the alternator joint.
Connect the charge coil
（
red / white
）
with the diverter.
•If the tested voltage of CDI is abnormal whereas the tested
voltage at the alternator is normal, poor contact or broken line
can be determined.
•If both are abnormal, bad act of charge coil can be determined.
Please refer to inspection of the charge coil table.
2.3.3 Trigger
*Note
Install the spark plug on the air cylinder head and inspect
with normal compression pressure.
Remove the 6P joint of CDI group, and connect a peak voltage
diverter between the trigger of 6P joint
（ blue/white terminal ）
to the wire and the 4P joint （ black terminal ） . Press the startup
electrical machinery or step on the actuating lever to measure
the peak voltage of the trigger.
Connecting method: positive pole connected with blue/white
line, and negative pole connected with black line.
Minimum voltage ： 1.7V or above.
*Note
The metal area of the avometer prod mustn't be touched
by fingers to prevent electroshock.
If the tested peak voltage at CDI terminal is abnormal,
disassemble the right body guard and the alternator joint.
Connect the trigger
（
blue / white
）
with the diverter. •If the
tested voltage of CDI is abnormal whereas the tested voltage at
the alternator is normal, poor contact or broken line can be
determined.
•If both are abnormal, bad act of trigger can be determined.
Please refer to inspection of the charge coil table.
白/绿
蓝/白
黑/红
黑/白
黑
蓝/白
Ω
Black/Red
Black/White
Black/Green Black
Blue/White
Blue/White