Qianjiang QJ150T-10, Operation And Maintenance Manual, Page: 110 / 131

- 109 -
Dismantle the guide pin.
Take down the left-half weldment of the driven wheel.
Dismantle the oil seal from the left-half part of the driven
wheel.
Check the free length of the clutch spring.
Allowable limit ： 70mm 。
Check the abrasion of the driven wheel.
Measure the external diameter of the right-half shaft sleeve
of the driven wheel.
Allowable limit
：
42.90mm
。
Measure the internal diameter of the left-half sliding sleeve
of the driven wheel.
Allowable limit
：
34.00mm
。
13.6.1 Replacement of the
right-half bearing of driven wheel
Take down the needle bearing from the right-half driven
wheel.
Dismantle the elastic check ring and the outer rolling
bearing.
Note:
The dismantled nearing can not be used again.
Rolling bearing
Elastic check ring
Needle bearing
Right-half of the driven wheel Left-half of the driven wheel
Free length
Oil seal
Guide pin
The left-half weldment of the
driven wheel