I
NSTALLING
H
ARDWARE
I
NSTALLING
THE
RRU
ON
A
P
OLE
2-6
Figure 2-5.
Securing Device to Wall Clamp
The device is now mounted to a wall.
Installing the RRU on a Pole
Before you begin any procedure make sure the necessary components and tools are
prepared. All screws must be tightened by using a Phillips #2 screwdriver.
Fixing the device to a pole is a two step process. First the provided clamp (A) must be
installed on the pole location. Then, the device is installed on the clamp.
Requirements:
Install the bracket on the device. See
Installing Bracket A on Device
2-3.
1. Select a mounting location on a pole to mount the device. The device can be
attached to a pole diameter of 5.1 to 20.1 cm (2 to 8 inches).
2. Hold both Clamps A and hold them against the pole. Ensure the directional marker
(arrow) is pointing upwards designating a correct bracket alignment.
CAUTION!
Ensure all power is disconnected from the system before proceeding.
!