Q CELLS Q.PEAK DUO BLK-G6+/AC, Installation And Operation Manual

Page: 18 / 25

34 35
INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.PEAK DUO BLK-G6+ / AC – Q CELLS INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.PEAK DUO BLK-G6+ / AC – Q CELLS
Installation and Operation Manual
 2020 Enphase Energy Inc. All rights reserved.
15
Step 3: Terminate the Unused End of the Cable
Place sealing caps on unused connectors and terminate the unused end of the Enphase Q Cable.
A. Cover any unused connectors with Enphase Sealing Caps. Listen for a click as the connectors
engage.
WARNING : Risk of electric shock. Risk of fire. Install sealing caps on all unused AC
connectors as these connectors become live when the system is energized. Sealing caps
are required for protection against moisture ingress.
NOTE : If you need to remove a sealing cap, you must use the Enphase Disconnect Tool.
See “Remove and Replace a Microinverter” on page 43.
B. Remove 13 mm (½ inch) of the cable sheath from the conductors. Use the terminator loop to
measure 13 mm.
C. Slide the hex nut onto the cable. The grommet inside of the hex nut should remain in place.
D. Insert the cable into the terminator body so that each of the two wires land on opposite sides of
the internal separator.
E. Insert a screwdriver into the slot on the top of the terminator to hold it in place and torque the nut
to 7 Nm.
F. Hold the terminator body stationary with the screwdriver and
turn only the hex nut to prevent conductors from twisting out
of the separator.
NOTE: Turn only the hex nut to prevent conductors
from twisting out of the separator.
G. Attach the terminated cable end to the PV racking with a
cable clip or tie wrap so that the cable and terminator do not
touch the roof.
WARNING : The terminator cannot be re-used. If
you unscrew the nut, you must discard the
terminator.
13mm
Terminator
Body
Internal view
Installation and Operation Manual
 2020 Enphase Energy Inc. All rights reserved.
16
Step 4: Prepare the AC Modules
A. Before installing the AC module, the microinverters must be lifted from the shipping position. On
the ground, turn the AC Module so that the microinverter faces you. Using both hands, lift the
microinverter up. You will hear four clicks as the microinverter locks into the installation position.
Ensure the four latches are locked, and the microinverter is not tilted.
NOTE : If you need to move the module, you can return the microinverter to the shipping position using
the Enphase Disconnect Tool. Use the tool to depress the four locking mechanisms on each corner of the
microinverter to return it to the shipping position.
B. Installer has to scan the microinverter Serial Number using the
Enphase Installer Toolkit mobile app.
C. Position the AC Modules as planned on the rail.
The Microinverter is in the shipping position.
The Microinverter is lifted and ready for installation.
Make sure the microinverter is not tilted.
Use this end of the disconnect tool
to depress the locking mechanisms.