3. Press the "SAVE" and "END" keys by turns. Both corresponding LEDs will light up.
4. Press the "SAVE" key again - the LED in "SAVE" key will go out. Now, press the "LOAD
PROGRAM" key - LED in the "END" key will also go out and the first scene of the program will
be launched. From now on, the program will be automatically rendered to the scene, where
you have put the "END" marker, and after that the program will be automatically rendered from
the beginning.
6.2. END MARKER EDITION
6
SAVE
+
END
END
SAVE
+
END
SAVE
SAVE
LOAD PROGRAM
6.3. SYNCHRONIZATION PROGRAMMING
Each program can be rendered with a different speed and synchronization. These parameters
must be programmed first.
1. With the left pair of "+" and "-" keys set the number of the program where you want to change
synchronization.
2. Press the "LOAD PROGRAM" key.
3. In the TRIGGERING block select a required synchronization mode.
4. If you select AUTO, adjust speed and step-to-step fading smoothness with the "SPEED" and
"X-FADE" sliders.
5. Press the "SAVE" and "SPEED" keys, both corresponding LEDs will light up.
1. If any LEDs in the TRIGGERING block are lit, turn them off by pressing the corresponding key.
2. With right "+" and "-" keys set the scene, on which the program ends. In the "END" key the LED
will light up automatically.
3. Press the "SAVE" key.
4. Press the "END" key - the corresponding LED will go out.
5. Press the "SAVE" key again. The corresponding LED will go out and the "END" marker will be
deleted.
You have two possibilities now:
1. You do not define a new program "END" marker - when the program finishes, the successive
program will be launched automatically.
2. You define program "END" marker in the other place, according to the description in chapter
6.1 of the present manual.
