13. CO-OPERATION WITH A PC COMPUTER
The controller is equipped with a standard serial port RS-232, that allows to connect it with the
computer. This connection can serve for:
1. sending the controller memory content to the PC, where the settings can be archived on the
hard drive,
2. rewriting the previously saved on the hard drive archival settings and programs,
3. adjusting all the controller's parameters with the PC,
4. updating the FirmWare applications, that control the PX126 operation.
Communication with the PC requires appropriate software installation, you can download the
application from producer's website:
www.pxm.pl
.
12
1. Connect the Mirage RL controller to the PC with the RS-232 cable (Mirage RL controller has to
be switched off!).
2. While holding the "PC" key switch the Mirage RL controller on. The "LINK" LED will light up.
3. Launch the "mirageRL_e.exe" application on your PC.
PC application
SPEED
PC
SPEED
PC
12.
FROM SOLO RL CONTROLLER
PROGRAMS COPYING
1. Connect the Mirage RL and Solo RL controllers with the programming cable (both devices have
to be switched off!).
2. When holding the "SPEED/PC" key pressed switch Mirage RL on. Yellow "PC" LED will light up.
3. Switch Solo RL on. "In" inscriptions will show on Solo RL display.
4. Press "+" or "-" key on Solo RL controller - the "Ou" will show on Solo RL display.
5. Press the "LOAD" key on Solo RL - the data transmission will start.
6. When the transmission is carried out properly, the "Ed" inscription will appear on Solo RL
display.
7. When errors appear during the transmission, "Er" insription will be displayed on Solo RL
controller. In such case return to p.1.
After launching the application, the window shown on the next page will appear on your PC
display screen.
Choose a bookmark:
- "FirmWare upgrade" - allows to install the latest software version in the Mirage RL controller
- "Action" - you can launch the tools for scenes, sequences and settings storage, or to control
PX126 with the PC.
