6.5. COLLECTIONS (CUEs) PROGRAMMING
The controller can render the scenes in two ranges of scene-to-scene change speed:
- 0.1 secs - 25 secs
- 10 secs - 40 mins
The appropriate range must be programmed.
If the slower range is programmed, LED "*100" is lit.
When the controller is switched off, press and hold "CLEAR" key in the OPERATIONS block and
switch the controller on. Hold the key pressed, until the software version number disappears from
the display. The speed range has been changed.
6.6. SPEED PROGRAMMING
8
MIDI
CUE
SAVE
SAVE
6
~ 5 s.
EXTRA
EXTRA
EXTRA
~ 5 s.
CLEAR
CLEAR
CLEAR
By pressing one of the EFFECTS keys during programs rendering you can cause (apart from
launching the scene, ascribed to this key) an automatic dimming of all the other devices
(BLACKOUT) until this key is released.
To turn this feature on:
1. By pressing the appropriate key (eg. EXTRA) check, if that causes BLACKOUT. If not, go to
point 2.
2. When the controller is switched off, press and hold the EXTRA key in the EFFECTS block and
switch the power on. Hold the key pressed, until the software version number disappears from
the display. The reaction to the EFFECTS keys has been changed.
3. To turn this feature off, proceed the procedure from point 2.
The controller is equipped with a very useful feature - collections programming. To each of 16
collections you can assign three (or less) programs.
1. Load the selected programs (refer to chapter 7 of the present manual).
2. Press the "SAVE" and "CUE" keys by turns.
3. In the CUE SELECTION block select a collection number.
4. Press the "SAVE" key again - the collection will be saved.
