7. PROGRAMS RENDERING
7.2. ANOTHER PROGRAM RENDERING START
Rendering the programs, saved in the controller's memory, is a basic operation mode of the
device. The programs rendering maintenance has been significantly simplified. It is confined to
program number selection or collection launching.
ATTENTION:
Directly after switching the controller on, the software version number is displayed for a few
seconds, after that the controller is automatically set in the stand-by mode with the "BLACKOUT"
feature turned on.
3. Press the "LOAD PROGRAM" key. The selected
program will be launched automatically, its number will be
displayed on this RUNNING PROGRAMS display, where
the decimal dots are visible.
1. Switch “BLACKOUT” off.
2. With "+" and "-" keys select the program number you want to render. In the "LOAD PROGRAM"
key the LED will light up, that means, the controller is ready to start rendering the selected
program.
7.1. ONE PROGRAM RENDERING START
7.3. PROGRAM RENDERING STOP
2. Press the CLEAR key.
1. With the arrow key (NEXT) set the dots on the program
display you want to switch off.
10
3. If you want to switch off all the running programs press
MIDI / CUE and CLEAR keys in turn.
CLEAR
MIDI
CUE
CLEAR
NEXT
-
LOAD PROGRAM
-
LOAD PROGRAM
NEXT
LOAD PROGRAM
-
MIDI
CUE
MIDI
CUE
MIDI
CUE
~ 5 s.
1. Perform all the activities described in the previous paragraph.
2. With the arrow key (NEXT) "move" the decimal dots to the next display.
3. Perform all the activities described in points 2 and 3 from the previous paragraph.
