MR2 Manual
Revision B
/
June 2021
Page 26
of
34
2.
Fill the fluid distribution block with lubrication fluid to the “
Fill
” line. If the lip seals
fail, material particles will be seen in the lubrication fluid.
Figure 53: Fill Line
3.
Install the breather vent and tighten with an adjustable wrench. Do not over tighten.
Install the MR2
1.
Install the four screws to attach the MR2 onto the assembly.
2.
Install the cover and install the cover screws.
Figure 54: MR2 with Cover
3. Install the MR2 onto the work station or in the workcell as necessary.
