PURSUIT S 408 SPORT 2017, Owner'S Manual

Page: 173 / 178

Additional Information Appendix G
G-5
CAUTION:
Replacing your old float switch
Confirm float being replaced is on the positive (+) side of the pump.
1. Cut and splice the RED wire on the model 101 to the (+) wire coming from the battery .
2. Cut and splice the BROWN wire from the model 101 to the positive pump wire.
3. Cut and splice the BLACK wire on the model 101 to common ground (-).
Common Wiring Configurations
* Keep connections high and dry
FUSE
Mount 1'' above standing water
12V
Cut \ Splice
Cut \ Splice
Cut \ Splice
R
E
D
BROWN
BLACK
From
Battery
FLO
AT
SWIT
CH
(-)
(+)
(+)
•
Connecting the BROWN wire to ground, as this may damage the switch.
•
Mount the Model 101 with sensor about 1” above standing water in your bilge.
•
Make all wire connections sealed and above any water contact.
3-way switch
OFF
ON
(-) (+)
*As recommended by pump manufacturer
OFF
ON
(-) (+)
Float Switch Wire Connections Float Switch Wire Connections
Bilge
Pump
Battery
Bilge pump
Battery
RED
BROWN (+)
Model
101
FUSE*
FUSE*
(+)
FLOA
T
SWITCH
BLACK (-)
(+)
AUTO
(-)
(+)
AUTO
LIMITED WARRANTY
WATER WITCH, INC. warrants this control for a period of 5 years from the date of purchase against defects in material and workmanship
providing it has not been subject to physical or electrical abuse or misuse. If it ceases to operate, return control, freight prepaid, with a copy
of your sales receipt. Water Witch, Inc. reserves the right to repair or replace the control at its option. IN NO EVENT WILL WATER WITCH,
INC. BE LIABLE FOR MORE THAN THE REPLACEMENT COST OF THE CONTROL UNDER THIS WRITTEN WARRANTY OR UNDER
ANY IMPLIED WARRANTY OR MERCHANTABILITY. This warranty gives you specific legal rights. However, you may also have other
rights which vary from state to state and country to country.
Water Witch, Inc. PO Box 710447 Santee, California 92072
1-800-654-4783 e-mail: info@WaterWitchInc.com www.WaterWitchInc.com
2-way switch
Every time power is applied, the Water Witch will operate the pump for several seconds in a self calibrate mode.
TESTING:
Test the Water Witch by placing a wet rag across the sensor and the metal mounting bracket for the 8 second delay period
required to turn on the pump.
OFF
ON
(-)
(+)
*As recommended by pump manufacturer
OFF
ON
(-) (+)
Float Switch Wiring Connections
Bilge
Pump
Battery
Bilge
Pump
Battery
RED
BROWN (+)
Model
101
FUSE*
FUSE*
FLOA
T
SWITCH
(+)
(-)
BLACK (-)
(+)
NOTE:
If large amounts of rain water can enter the bilge, it may dilute the normal, fresh or salt, water outside our sen-
sitivity window. Corrective action can be to switch pump on manually to remove diluted water or to add miner-
als such as salt, baking soda, bilge cleaners, etc… NORMAL FRESH WATER HAS AMPLE MINERAL CON-
TENT FOR PROPER OPERATION.