PURSUIT Denali 28, Owner'S Manual

Page: 34 / 148

DENALI 28
Fuel Withdrawal Tubes
The fuel withdrawal tubes are positioned in the fuel tanks to achieve optimum fuel usage, fuel line
routing, etc. At certain speeds and hull trim angles, the fuel supply at the withdrawal tank location
can increase or decrease accordingly. Be extremely careful when attempting to operate the boat
when low on fuel. Though some fuel may be in the tank, the relative trim angle of the boat may
cause the fuel to flow away from the withdrawal.
Fuel Gauge
This indicates the amount of fuel in the tanks. Due to the mechanical nature of the fuel sender,
variations in readings during various speeds of operation may occur. This system is merely a
relative indication of the available fuel supply and not a calibrated instrument.
Fuel Fills
A fuel fill deck plate is located on each gunnel, and is marked “GAS.”
The fuel fill is opened by turning it counter clockwise with a special key.
After fueling, install the fuel cap and tighten with the key. Be sure to use
the proper type and grade fuel. Refer to the engine owner’s manual for
additional information.
Note: Do not overtighten the fuel cap. If the cap is overtightened, the O-ring seal could be
damaged allowing water to contaminate the fuel system.
DO NOT CONFUSE FUEL FILL DECK PLATES WITH THE WATER OR WASTE FILL DECK
PLATES. THESE PLATES ARE ALSO LABELED ACCORDINGLY. IF GASOLINE IS ACCI-
DENTALLY PUMPED INTO THE WATER OR WASTE TANK, DO NOT ATTEMPT TO PUMP
IT OUT YOURSELF. WATER AND WASTE PUMPS ARE NOT DESIGNED TO PUMP FUEL
AND A FIRE OR EXPLOSION COULD RESULT. CONTACT YOUR DEALER OR THE PUR-
SUIT CUSTOMER RELATIONS DEPARTMENT FOR ASSISTANCE IN HAVING THE FUEL
PROFESSIONALLY REMOVED.
Fuel Vent
There are two fuel vent fittings, one on each side of the hull. While the tank is being filled, the air
displaced by the fuel escapes through the vent. When the tank is full, fuel will be ejected from the
fuel vent.
After fueling, replace the fill cap, and wash the areas around the fuel fill plate and below the fuel
vent. Residual fuel left on the deck and hull side can be dangerous and will yellow the fiberglass
or damage the striping.
Fuel Fill
3-2