PURSUIT Denali 28, Owner'S Manual

Page: 29 / 148

DENALI 28
Steering System
(For a detailed schematic, see Chapter 15)
transom is called trimming “out” or “up”. In most cases, the boat will run best with the drive unit
adjusted so the hull will run at a 3 to 5 degree angle to the water.
The term “trim” generally refers to the adjustment of the outdrive within the first 20
o
range of travel.
This is the range used while operating your boat on plane. The term “tilt” is generally used when
referring to adjusting the outdrive further up for shallow water operation or trailering. For
information on the proper use and maintenance of the power tilt and trim, please refer to the engine
owner's manual.
EXCESSIVE TRIM FOR THE OPERATING CONDITIONS, EITHER TRIM UP OR DOWN, CAN
CAUSE BOAT INSTABILITY, PROPELLER CAVITATION, OR MAKE STEERING THE BOAT
MORE DIFFICULT. IF THE BOAT BEGINS TO FEEL UNSTABLE OR IS HARD TO STEER,
SLOW DOWN AND ADJUST THE TRIM ANGLE.
2.6 Steering System
Your Denali is equipped with a power assisted cable steering system. Turning the wheel moves
the gears in the helm, pushing or pulling the cable assembly and turning the outdrive(s). An engine
driven power steering pump and cylinder assist the cable steering and reduces the effort required
to turn the boat.
Dual engine sterndrive boats have two outdrives. These are coupled together at the tiller arms by
a tie bar. Dual outdrives are not toed-in at the front. They are set parallel to provide maximum
stability on straight ahead runs and proper tracking through corners. Outdrive or steering system
damage may require the outdrives to be realigned.
Please refer to the engine owner's manual or contact your dealer for information on the power
steering system.
2-3