PULSAR MEASUREMENT
11
MENU SELECTIONS
The Menu selections page is used to navigate to specific menus which are
described in more detail on the following pages.
Press
or
to navigate to different menus, and
to enter the selected
menu.
UNITS/MODE
At
Mode
, press the
and then the
or
to select Flow or Velocity. Flow
mode displays the flow rate in engineering units (e.g. gpm, litres/sec, etc.)
Press the
to store your selection then the
to the next menu item.
At
Linear
press the
key and then the
or
to select your units of
measurement. The Linear units define what units the pipe/channel dimensions
and level reading will be displayed in. Typically inches or mm is selected. Press
the
to store your selection then the
to the next menu item.
At
Volume
, press the
and then the
or
to select units for volume.
Note: “bbl” denotes US oil barrels. Press the
to store your selection then the
to the next menu item.
At
Multiplier
, press the
and then the
or
to select the totalizer
multiplier. Multipliers are used when resolution down to single digit is not
required, or when you don’t want to convert from gallons to thousands of
gallons, as an example. Press
to store your selection then
to the next
menu item.
At
Decimal
(Volume), press the
and then the
or
to select the
number of decimal points to be present on the totalizer display on the LCD
screen. Default = 0. Options = 0, 1, 2. Press the
to store your selection then
the
to the next menu item.
At
Velocity
, press the
and then the
or
to select the
engineering units for flow velocity and sonic velocity of the fluid. Press
to
store your selection then
to the next menu item.
--Menu--------------
Units / Mode
Calibration
Relay Parameters
Data Logging
Communication
Special Functions
Simulation
Configuration
--Units/Mode--------
Mode
Flow
Linear
in
Volume
USG
Multiplier
x1
Decimal
0
Velocity
ft/s
Flow
USG/m
Decimal
2
emperature
T
F
