7
2
3
4
5
3
1
15 Nm
!
15 Nm
!
1mm
1
1
A
1,5mm
1,5mm
+
+
+
-
-
-
1
1
2
1
2
2
5-8 Nm
GB
The brake on this bike has already been installed and
adjusted by PUKY. Make sure that the brake pads
are parallel to each other and that they are properly
aligned with the rim. This means that the brake pads
should rest 1 mm below the top edge of the rim. If
these settings are not correct, loosen the fasten-
ing nut of the brake pad (1) and align as described
above. To do so, pull the brake lever and re-tighten
the fastening nut (5-8 Nm).
Tighten the screw.
Please pay attention to the marking!
To set the steering wheel height, loosen the screw
and then retighten it. Do not go below the minimum
insertion depth (marker)! Before tightening the
screw, make sure that the steering wheel is aligned
straight in driving mode.
SETTINGS CONTROL AND FINE
ADJUSTMENT OF THE V-BRAKE
(ONLY FOR MODEL R 07 L UND JOKER)
Required tool
(not included)
• Cross-headed screwdriver
• Allen key 5 mm
Push the end of the lever (1)
to release the safety clip (2).
Brake cable tension is adjusted at the anchor nut (A)
so that each brake pad maintains a distance of 1.5
mm to the rim.
If an adjustment needs to be made, the protruding
wire end should then be refastened to the brake .
Now centre the brake arms by turning the adjusting
screw. You will need a crosstip screwdriver for this.
It is important that the brake levers are actuated
several times so that the tension of the brake arms
is evenly distributed to both sides and the settings
take effect . The brake/rim contact must be iden-
tical on both sides .
