14
fold is above the perforation, then move the paper stop away from the open
end of the fold plate. If the fold is below the perforation, then move the
paper stop towards the open end of the fold plate.
Paper Feed Problems
Double Feeds
If you’re having problems with two forms feeding at once:
1. Turn
the
Feed Gauge Adjustment Screw
[see Figure 8] ¼ turn
counter-clockwise.
2. Try running the forms again.
3. If the problem persists:
a. Try another ¼ turn on the
Feed Gauge Adjustment Screw
.
b. Try reducing the size of the paper stack on the
Feed Table
.
c. Try resetting the
Feed Gauge
.
Won’t Feed
If the
ENDEAVOUR
won’t feed forms through:
1. Try reducing the size of the paper stack on the
Feed Table
.
2. Try resetting the
Feed Gauge
.
ENDEAVOUR Won’t Run
If the
ENDEAVOUR
won’t run when the
On-Off
switch is operated:
1. Check that the
ENDEAVOUR
Power Switch Breaker
, located by the
power plug, is not in the tripped (out) position. If it is, press it in. If the
breaker button will not stay pressed in, wait a minute and try again.
2. Check that the
Access Panel
on the side cover opposite the control
panel is properly in place.
3. Make sure the power switch by the power cord is in the
On
position.
4. Double-check that the power cord is properly connected to the machine
and an appropriate socket [see
Setup
].
5. Check that the wall socket which the machine is connected to is
functioning properly.
