8
2. Insert the provided
3/16” T-Handle Hex Driver
into
Feed Gauge
Adjustment Screw.
3. Turn
the
T-Handle Hex Driver
¼ turn clockwise to loosen the
Feed
Gauge
Roll
.
4. Place one form on the feed table and hand feed the form about 2
inches into the
ENDEAVOUR
by moving the feed belt with your hand.
5. Turn
the
T-Handle Hex Driver
¼ turn counter-clockwise.
6. Pull the paper out of the machine. You should feel resistance, but not
too much. Repeat Steps 4-6 until there is a moderate amount of
resistance when pulling the form out. If it feels too tight, turn the T-
Handle Hex Driver ¼ turn clockwise.
7. Return the T-Handle Hex Driver to the toolkit.
Loading the Feed Table
Before loading the feed table, square up the stack of paper you are going to
load by placing it on edge on a flat surface. Place the stack onto the table
so that the front of the stack butts up against the feed gauge cover [do not
push hard].
The proper orientation of the paper when loaded onto the feed table
depends on the type of fold you are using and the layout of your form.
Table 2 shows the order in which folds will be performed when run through
the machine with the right hand paper edge being loaded into the machine
first (red arrow shows paper path).
All forms should be loaded with glue on the leading edge facing up (the
glue is usually visible as yellow, blue or red stripes around the edge of the
form). With
Z
&
EZ Folds
you have multiple ways to load the form and still
have glue on the leading edge facing up, either one will work. With
EZ
Folds
, though, care must be taken to ensure that the upper fold plate is set
to the proper length for the leading fold (the bottom fold plate setting
remains the same either way).
Feed Table Capacities
11” Forms: 150 Sheets
14” Forms: 100 Sheets
